Designed specifically for the high performance pumps PUMP 130, this controller allows you to bring the 12 V of a normal car battery to 24 V constant, thus maximizing the potential of the pump bleeder. To operate, simply connect the controller to the car battery or battery pack via alligator clips, taking care to observe the polarity and the voltage is set to the minimum, and connect the pump to the controller via the 2-pin plug .

IMPORTANT The controller can not operate if the supply voltage is below 11 V, this threshold is reached, a safety circuit interrupt the operation. Please see the information sheet of the pumps for details on consumption. To prevent damage to the pump or the regulator itself, be sure to connect the pump to the regulator strictly off via the pawl "Flow Control".

If the regulator were to be powered by a car battery, please note that due to the high performance, the pump has a high consumption and the car, even when on, you may not be able to keep the battery charged sufficiently for a long time.

RECOMMENDATIONS For proper operation of the pump is recommended to increase the voltage of the booster very slowly, avoiding sudden ignitions. When the booster operates at full power the power consumption is very high and may cause behavior "hiccups" when the battery power is not fully charged.